6 Common Causes of Hand Tools Accidents

Reading Time: 3 minutes

First published: 19 August 2021 @ 6:00 pm

Cause #2: Bad Technique Is Being Used

In many cases, accidents happen because of poor technique being used by the person using the tool. For example, one person stated that he lost control of his hand-held circular saw because of poor technique.

Another person said that he got hurt when making an adjustment on his table saw because of bad technique. One of the most common causes of accidents with hand tools is not following proper safety procedures or techniques.

For example, one man stated that if he had put on a dust mask before cutting sheet metal, then his injury would not have been as severe. Another person stated that if he had used a proper wrench when tightening the bolt on his lawnmower, then he would not have broken his hand.

Cause #3: Poor Maintenance Is Being Done

A lot of accidents happen because of poor maintenance being done on hand tools. For example, one man stated that his cordless drill battery ran out of power before he could finish working on his car, so he had to stop working on it and go home without finishing what he had started.,

Another man stated that after fixing his power tool’s belt, it started leaking oil again, so he had to take it back to the shop and have it fixed again. Another man stated that he accidentally put his hands in the air when he was using a cordless drill, so he got a lot of splinters in his hands.

If you feel that your hand tools are not being properly maintained, then you should start doing some maintenance on them.

Don’t forget to share this to your fellow woodworkers if you found it helpful to prevent them suffer from hand tools accidents!